EHRS4-OUT : Hirose 4pin - Straight
- 24″ / 60cm straight cable with molded battery connector.
- Hirose 4pin male end connector
EHRS4RA-OUT : Hirose 4 pin - Right Angle
- 24″ straight cable with molded battery connector.
- Hirose right angle 4 pin male end connector
ECOIL-OUT : Battery output coiled cable - no connector
3′ 2-conductor coiled cable (extends to 5′) with molded battery connector. Delivered without connector.
EZAXRX-OUT : Power for Zaxcom RF Receivers
Battery output cable with locking right angle connector. Plugs directly into AUDIOROOT smart batteries (eSMART Li-49Wh and 98Wh). Switchcraft 761K compatible molded connector. Special lengths on request.
- Cable length : 20cm (8′)
- DC barrel connector inner diameter : 2.5mm
- DC barrel connector outer diameter : 5.5mm
- Cable diameter : 4.4mm
- Conductor gauge : 20AWG
- Receiver compatibility : RX900, QRX100, QRX200 and QRX235
ESRARX-OUT : Power cable for Lectrosonics SRa and SRb receivers
Battery output cable with locking right angle connector. Plugs directly into AUDIOROOT smart batteries (eSMART Li-49Wh and 98Wh). Switchcraft S760K compatible molded connector. Special lengths on request.
- Cable length : 20cm (8′)
- DC barrel connector inner diameter : 2.1mm
- DC barrel connector outer diameter : 5.5mm
- Cable diameter : 4.4mm
- Conductor gauge : 20AWG
- Receiver compatibility : Lectrosonics SRa and SRb RF receivers
EXLR4-OUT : XLR 4pin female
- 24″ / 60cm straight cable with battery connector.
- Neutrik XLR4F end connector
ECON-OUT : Battery output cable - no connector
60cm straight cable with molded battery connector. End connector not included. Available in 2 versions :
- eCON-OUT : 2 conductor cable (power only)
- eCON-OUT-4W : 4 conductor cable (power + smBUS data/clk lines)
EHRS4-HSW-4W : Hotswop battery cable for eSMART BG-DU
This cable can be used to connect 2 x AUDIOROOT eSMART batteries on a BG-DU or BG-DU-REG for simultaneous use or hotswapping.
Important notes :
- As this cable is passive the BG-DU will display battery telemetry from only 1 battery when 2 batteries are connected. The battery from which battery info is read is selected randomly (first battery to respond to smbus master commands).
- It is always the battery with highest voltage which handles the load. As the batteries’ voltage balance themselves during use they will tend to share the load 50/50.
At that point current and power information shown on the BG-DU will correspond to half the actual values and estimated runtime will be correct.
Overall length : 60cm – custom lengths on request
Found a lower price? Complete this simple form: