The HDMI Over IP Extender with PoE from MuxLab multicasts digital video and audio signals to one or more receivers up to 330' (100m) away using CAT5e/6 cable.
Each HDMI Over IP Extender consists of a local unit that connects to an HDMI source, and a remote unit that connects to an HDMI source. The local and remote units can be connected together for a point-to-point connection, or through VLAN isolation on a managed network switch for a multipoint-to-multipoint configuration. However, for the multipoint-to-multipoint configuration the gigabit Ethernet switch must support the IGMP communications protocol.
___________________________________________________________
The kit includes both an encoder and decoder. The encoder converts an HDMI bit stream into IP allowing it to be transmitted over an Ethernet LAN. The HDMI decoder converts the IP packets back to the original HDMI bit stream for playback via an HDMI display.
Environment | HDMI 1.3a, Ethernet, IGMP |
Devices | DVD, plasma, projectors, monitors, TV, PC, laptops, servers supporting HDMI |
Transmission | Transparent to the user |
Bandwidth | 225 MHz |
Compression | MJPEG |
Bit Rate | 60 Mbps |
Latency | With one (1) frame at 30 fps, there is 33 msec latency |
Network Requirements | Point to Point: 100BaseT Multipoint: 1000BaseT |
IR Frequency | 38 KHz |
Configuration | Point-to-Point, Point-to-Multipoint, Multipoint-to-Multipoint* *For multipoint-to-multipoint configuration the Gigabit Ethernet switch must support the IGMP communications protocol |
Connectors | HDMI receptacle x 1 RJ-45S for Cat 5e/6 unshielded or shielded twisted pair via 10/100BaseT x 1 3.5mm jacks for IR emitter/sensor x 1 DIP switches for device ID addressing x 4 |
DIP Switch | 4-position DIP to set Device ID |
Maximum Distance | Based on a maximum length of 6.6' (2 m) of HDMI cable per end: Cat5e/6: 330' (100 m) up to 1080p* *Gigabit Ethernet required for 1080p
Note: When installed in an electrically noisy environment, an STP cable must be used. Also, cross-connection reduces the effective distance depending on the grade of twisted cable used |
RJ45 Pin Configuration | RJ-45 Link: Pin 1 (R) Pin 2 (T) Pin 3 (R) Pin 6 (T) Pin 4 (R) Pin 5 (T) Pin 7 (R) Pin 8 (T) |
Cable | One (1) Cat 5e/6 or better twisted pair cables required |
Power Supply | PoE power Optional 5 V/1.2 A universal power supply sold separately |
Power Consumption | Transmitter: 2.9 W Receiver: 1.8 W |
Temperature | Operating: 32-104°F (0-40°C) Storage: -4-185°F (-20-85°C) |
Humidity | Up to 95% non-condensing |
Enclosure | Metal |
Compliance | Regulatory: FCC, CE, RoHS Flammability: 94V0 |
Dimensions | 3.7 x 3.68" x 0.97" (94 x 93.5 x 24.6 mm) |